Skip to content
LicenseReciprocity

Contractor License from Texas to Wisconsin: Does It Transfer? (2026)

Last verified: 2026-08-07 · source: Wisconsin Department of Safety and Professional Services (DSPS) — Division of Professional Credential Processing ↗

A contractor license transfers from Texas to Wisconsin by endorsement — there is no automatic reciprocity, but you do not start over. Apply to the Wisconsin Department of Safety and Professional Services (DSPS) — Division of Professional Credential Processing, verify your Texas license, and meet Wisconsin's endorsement requirements. Wisconsin has no state general or commercial contractor licence — commercial building is permitted locally, and one- and two-family work requires a DSPS Dwelling Contractor certification plus a Dwelling Contractor Qualifier, neither of which offers reciprocity. Only electrical licensing offers a genuine exam waiver: a Journeyman Electrician licence acquired through a state examination in Iowa (Journeyman A) or New Hampshire, held continuously for at least one year immediately before applying, may be converted to a Wisconsin Journeyman Electrician licence without the Wisconsin exam. Master Electrician reciprocity is narrower still — Iowa Master A only. Plumbing has no reciprocity; an out-of-state plumbing licence counts only as experience toward the Wisconsin exam..

Verify this exact pair in the checker

Same data, interactive — with share link and board links.

Run the Reciprocity Checker →

Verdict

Licensure by endorsement

Wisconsin does not have a trade agreement covering Texas for the selected trade, so this move runs on Wisconsin's case-by-case endorsement process. If you do commercial general-building work, check whether Wisconsin accepts the NASCLA exam — passing it once can replace the trade exam here and in about fourteen other states. Electricians should check Wisconsin's NERA status.

What changes, Texas → Wisconsin

Side-by-side: Texas vs Wisconsin (Contractor (GC/electrical/plumbing/HVAC)), verified 2026-08-07
Texas (current)Wisconsin (destination)
Application fee$30–$115 (Fees differ by agency and trade: TDLR journeyman electrician $30 and master electrician $45; TSBPE reciprocal license verification $40 non-refundable, plus the IdentoGO fingerprint fee; TDLR ACR out-of-state application $115. There is no state general-contractor license fee because Texas does not license general contractors.)$100–$200 (DSPS trades credential fees on a 4-year cycle: Journeyman Electrician $100, Master Electrician $200. The exact initial fee for a reciprocity application is calculated in the LicensE portal and is not published as a flat figure. For context, the non-reciprocal Dwelling Contractor certification is $25, Dwelling Contractor Qualifier $30, and HVAC Contractor $160.)
Processing timeNo single figure applies. TSBPE states a reciprocal plumbing license arrives by US mail within 30 days of the completed online application and payment; TDLR publishes no processing time for electrician or ACR reciprocity.DSPS reviews the application and then makes the applicant eligible; no processing-time range is published. Requested documents must be uploaded within three months or the application and fees must be resubmitted.
Licensing authorityTexas Department of Licensing and Regulation (electricians, air conditioning and refrigeration) and Texas State Board of Plumbing Examiners (plumbers); no state general-contractor licenseWisconsin Department of Safety and Professional Services (DSPS) — Division of Professional Credential Processing

The destination column is what you must satisfy — Wisconsin sets the rules for this move.

Step by step

  1. Confirm Wisconsin's current requirements on the Wisconsin Department of Safety and Professional Services (DSPS) — Division of Professional Credential Processing website (linked below) — rules change.
  2. Submit the endorsement application to the Wisconsin Department of Safety and Professional Services (DSPS) — Division of Professional Credential Processing (application linked below).
  3. Arrange license verification from your current state.
  4. Hold a valid unexpired Iowa Journeyman A or New Hampshire Journeyman Electrician licence acquired through that state's examination.
  5. Have held that licence continuously for at least one year immediately before applying in Wisconsin.
  6. New Hampshire applicants must have completed an electrical apprenticeship-schooling programme of at least 600 hours, 24 of them safety related.
  7. Apply and pay through the DSPS LicensE portal and upload the completed Experience Table (Form 3106T for journeyman, 3107T for master).
  8. Dwelling Contractor Qualifier applicants must complete at least 12 hours of an approved initial qualifier course within one year before applying — no reciprocity is available.
  9. Pay the fees ($100–$200 (DSPS trades credential fees on a 4-year cycle: Journeyman Electrician $100, Master Electrician $200. The exact initial fee for a reciprocity application is calculated in the LicensE portal and is not published as a flat figure. For context, the non-reciprocal Dwelling Contractor certification is $25, Dwelling Contractor Qualifier $30, and HVAC Contractor $160.)) and allow DSPS reviews the application and then makes the applicant eligible; no processing-time range is published. Requested documents must be uploaded within three months or the application and fees must be resubmitted..

Official links

Related guides

Frequently asked questions

Does Wisconsin accept a Texas contractor license?

A contractor license transfers from Texas to Wisconsin by endorsement — there is no automatic reciprocity, but you do not start over. Apply to the Wisconsin Department of Safety and Professional Services (DSPS) — Division of Professional Credential Processing, verify your Texas license, and meet Wisconsin's endorsement requirements. Wisconsin has no state general or commercial contractor licence — commercial building is permitted locally, and one- and two-family work requires a DSPS Dwelling Contractor certification plus a Dwelling Contractor Qualifier, neither of which offers reciprocity. Only electrical licensing offers a genuine exam waiver: a Journeyman Electrician licence acquired through a state examination in Iowa (Journeyman A) or New Hampshire, held continuously for at least one year immediately before applying, may be converted to a Wisconsin Journeyman Electrician licence without the Wisconsin exam. Master Electrician reciprocity is narrower still — Iowa Master A only. Plumbing has no reciprocity; an out-of-state plumbing licence counts only as experience toward the Wisconsin exam..

What still applies even if reciprocity covers my trade?

Wisconsin's business and law exam, financial statement, bond, and registration — reciprocity waives the trade exam only, not these.

What does the Texas-to-Wisconsin move cost and how long does it take?

$100–$200 (DSPS trades credential fees on a 4-year cycle: Journeyman Electrician $100, Master Electrician $200. The exact initial fee for a reciprocity application is calculated in the LicensE portal and is not published as a flat figure. For context, the non-reciprocal Dwelling Contractor certification is $25, Dwelling Contractor Qualifier $30, and HVAC Contractor $160.); processing DSPS reviews the application and then makes the applicant eligible; no processing-time range is published. Requested documents must be uploaded within three months or the application and fees must be resubmitted..

Would the NASCLA exam help for this move?

If you do commercial general-building work, possibly — about 15 states accept the NASCLA Accredited Commercial General Building exam toward licensure. Check whether Wisconsin is one on the Wisconsin Department of Safety and Professional Services (DSPS) — Division of Professional Credential Processing site.

Sources

Primary sources only — official boards and compact commissions. Data last verified 2026-08-07.

Reviewed by Billy Reiner, Editor · verified against primary sources 2026-08-07

How we verify · All sources · spot an error? [email protected]