Electrician License from Georgia to Connecticut: Does It Transfer? (2026)
Does Connecticut accept a Georgia electrician license?
No — Connecticut has no reciprocity or endorsement path for Georgia electrical license holders. You must apply to the Connecticut Department of Consumer Protection - Electrical Work Examining Board as a new applicant and meet Connecticut's full licensing requirements, including any exams it requires that you have not already passed.
Verify this exact pair in the checker
Same data, interactive — with share link and board links.
Verdict
Full re-application
Connecticut recognizes no other state's electrician license, so coming from Georgia means a full application rather than a transfer. The path is the new-applicant track with your experience as an accelerant: your Georgia hours on the tools usually count toward Connecticut's experience minimum, and the exam draws on code knowledge you already use daily. Pull the Connecticut Department of Consumer Protection - Electrical Work Examining Board's requirements early and treat any required coursework as review, not new ground.
What's different between Georgia and Connecticut
Computed from both states' verified data rows, in both directions, and from the route every other origin gets into Connecticut. Exam notes are our summary of each board's published rules, with sources below.
- Route, each way
Georgia to Connecticut (this page): Full re-application.
Connecticut to Georgia (the reverse move): Licensure by endorsement.
The two directions differ: Georgia and Connecticut do not give each other's licensees the same route.
- Does coming from Georgia matter?
Coming from Georgia does not change the answer: every origin (the other 49 states and DC) gets the same result for a move into Connecticut.
- Application fee
Connecticut lists $90 for an out-of-state applicant and Georgia lists $40 for the reverse move; neither may be the full cost.
- Experience hours
Connecticut's first-time-applicant standard is 8,000 hours of documented experience for the journeyman license; Georgia has no experience hours figure on file, so the two cannot be compared here.
- Exam rules on record
Connecticut and Georgia carry different exam notes (our summaries, below); any state law or jurisprudence exam is listed with each state's requirements.
- Connecticut (this move): Connecticut has no reciprocity and waives its exam for no one; an out-of-state journeyperson must document an equivalent out-of-state E-2 license (one issued after 720 classroom hours and 8,000 hours of on-the-job training) and must still pass the Connecticut E-2 journeyperson licensing exam
- Georgia (the reverse move): Georgia issues no journeyman electrician license; for its statewide electrical CONTRACTOR license the Board waives the exam only for applicants who hold a Non-Restricted (Class II) license obtained by examination in Alabama, Louisiana, North Carolina, South Carolina, or Tennessee, with no violations — every other applicant must pass the Georgia electrical contractor examination
What changes, Georgia → Connecticut
| Georgia (current) | Connecticut (destination) | |
|---|---|---|
| Experience hours | — | 8,000 |
| Application fee | $40 ($30 application + $10 processing (non-refundable) for the electrical contractor reciprocity application; see the Board fee schedule for the license-issuance fee) | $90 (E-2 journeyperson application fee is $90 (renewal $120). Exam fees are charged separately by the exam vendor. Application fees are non-refundable) |
| Processing time | The Board publishes no official processing-time figure for reciprocity | DCP does not publish a processing time for the equivalent-out-of-state review |
| Licensing authority | Georgia State Board of Electrical Contractors (Construction Industry Licensing Board, Office of the Secretary of State) | Connecticut Department of Consumer Protection - Electrical Work Examining Board |
The destination column is what you must satisfy — Connecticut sets the rules for this move.
Step by step
- Review Connecticut's initial-licensure requirements on the Connecticut Department of Consumer Protection - Electrical Work Examining Board website (linked below).
- Expect to meet Connecticut's education/experience requirements and pass any required exams you have not already passed — a national exam you passed often still counts, as can prior out-of-state licensure toward experience.
- Submit the standard (new applicant) application with fees listed above, and allow for the processing time shown there.
- Allow DCP does not publish a processing time for the equivalent-out-of-state review.
Official links
Related guides
Frequently asked questions
Do my Georgia hours count when I apply in Connecticut?
Generally yes — documented out-of-state experience usually counts toward Connecticut's experience-hour requirement, even where the license itself does not transfer. It shortens the qualification, not the exam.
Sources
Primary sources only — official boards and compact commissions. Data last verified 2026-07-21.
- CT DCP — Electrical License (states no reciprocal agreements with any jurisdiction; fees) ↗ (accessed 2026-07-21)
- CT DCP — Electrical Journeyperson, Equivalent Out of State License (720 classroom + 8,000 OJT hours) ↗ (accessed 2026-07-21)
- CT DCP — Electrical License Types and Scope of Work (E-1 = unlimited contractor, E-2 = unlimited journeyperson) ↗ (accessed 2026-07-21)
- Georgia SOS — Board of Electrical Contractors FAQ (reciprocity states, exam waiver, grandfather exclusion) ↗ (accessed 2026-07-21)
- Georgia SOS — Electrical Reciprocity Application (Form 44) ↗ (accessed 2026-07-21)
- Georgia SOS — Georgia State Board of Electrical Contractors (board home) ↗ (accessed 2026-07-21)
Reviewed by the License Reciprocity Editorial Team · verified against primary sources 2026-07-21
How we verify · All sources · Corrections log · spot an error? hello@licensereciprocity.com